Dock leveller model HL/P |
| |
The sara Model HL/P Electro-Hydraulic Dock Leveller has a heavy duty steel construction incorporating a sub frame for mounting on the pit base. Designed, tested and manufactured to comply with BS EN 1398 with a full operational load capacity ranging from 3,000 - 10,000kg per single axle load (4,500 - 14,500 rated). Heavier duty capacities are available.
|
|
|
|
Features
- Platform manufactured from 8mm Dubar non-skid steel plate.
- Standard hydraulic swing lip, also constructed from Durbar non-skid steel plate, 400mm long, 15mm thick, and chamfered at the leading edge for smooth transfer of wheeled traffic.
- The platform is supported by purpose-made longitudinal angles hinging at the rear on pivot shafts manufactured from ST52 grade steel.
- Hot rolled steel angle 100 x 50 x 8mm, is used as opposed to cold formed angle, to provide maximum strength and flexibility to the platform deck.
- Electrical motor is 220-240V/380-420V 3 Phase 1.1kw.
- The standard paint finish is red gloss (RAL 3000).
|
|
| |
|
|
| |
Optional extras
- Special heavy-duty capacities
- Under platform insulation
- Extended hinged lips
- galvanised finish
- VS 'Intelligent' dock buffer system
- Special non-skid surfaces
- Steel supporting constructions with handrails
- Installation pouring pans
- Side sealing brush strips
|
- Special colour finishes
- Interlocks with other dock equipment
- Composite control boxes
- Automatic return to dock level
- Special sizes to suit existing pits
- Steel pit edge angle set available (for casting in)
- Pre-cast concrete pits
- LED traffic lights
|
|
